MODEL |
PSF-125-5 |
PSF-125-12 |
PSF-125-15 |
PSF-125-24 |
PSF-125-28 |
PSF-125-48 |
OUTPUT |
DC Output |
5V |
12V |
15V |
24V |
28V |
48V |
Rated Current |
20A |
10.5A |
8.4A |
5.2A |
4.5A |
2.6A |
Current Range Note 1 |
0~20A |
0~10.5A |
0~8.4A |
0~5.2A |
0~4.5A |
0~2.6A |
Ripple and Noise Note 2 |
100mV |
100mV |
100mV |
100 mV |
120 mV |
150 mV |
Voltage ADJ. Range |
±10% of rated output voltage |
Voltage Accuracy |
±2.0% |
±2.0% |
±2.0% |
±2.0% |
±2.0% |
±2.0% |
Line Regulation |
±0.5% |
±0.5% |
±0.5% |
±0.5% |
±0.5% |
±0.5% |
Load Regulation |
±2.0% |
±2.0% |
±2.0% |
±2.0% |
±2.0% |
±2.0% |
Set-up Time |
<=1200mS (230Vac input, Full load) <=2500mS (115Vac input, Full load) |
Hold up Time |
>=17mS(115/230Vac input, Full load) |
Temperature Coefficient |
±0.03%/°C |
Overshootand Undershoot |
<5.0% |
INPUT |
Voltage Range |
90Vac~264Vac |
Frequency Range |
47Hz--63Hz |
Power Factor(Typical) |
PF>0.98/115VAC PF>0.93/230VAC |
Efficiency ( Typical) |
82%/115Vac |
85%/115Vac |
85%/115Vac |
85%/20Vac |
85%/115Vacin |
86%/115Vac |
84%/230Vac |
87%/230Vac |
87%/230Vac |
87%/230Vac |
87%/230Vac |
88%/230Vac |
AC Current (max.) |
1.5A |
1.5A |
1.5A |
1.5A |
1.5A |
1.5A |
Inrush Current (Typical) |
60A@230Vac 30A@115Vac Cold start |
Leakage Current |
<3.5mA |
PROTECTION |
Over Current |
105%~150% of rated output current, hiccup mode, auto recovery |
Over Voltage |
120%~150% of rated output voltage,hiccup mode |
Short Circuit |
Auto recovery |
ENVIRONMENT |
OperatingambTemp& Hum |
-20°C~60°C; 20%~90%RH No condensing |
Storage Temp. & Hum. |
-40°C~85°C; 10%~95%RH No condensing |
SAFETY &EMC
Note 3 |
Safety Standards |
GB4943-2001; EN60950-1: 2006 |
Withstand Voltage |
Primary-Secondary:3.0KVac;≤10mA .Primary-PG:1.5KVac;≤10mA .Secondary-PG:0.5KVDC; ≤10mA . |
Isolation Resistance |
100M ohms |
EMI Conduction&Radiation |
Compliance to EN55022(CISPR22)ClassB |
Harmonic Current |
Compliance to EN61000-3-2,-3 |
EMS Immunity |
Compliance to EN61000-4-2,3,4,5,6,8,11;ENV50204,light industry level,criteriaA |
OTHERS |
MTBF (MIL-HDBK-217F) |
More than 100,000Hrs (25°C, Full load) |
Dimension (L*W*H) |
127X76X30.5mm |
Connection |
7P/8.025mm barrier terminal block |
Packing |
21PCS/CTN, G.W:8.46kgs |
Cooling method |
Cooling by free air convection
|
NOTE |
1. All parameters NOT specially mentioned are measured at rated input, rated load and 25°C of ambient temperature.
2. Measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1 uF & 47uF parallel capacitor.
3. The SPS is considered a component which will be installed into final equipment. The equipment must be re-confirmed that it still meets EMC directives. |
